Need a little help here..

[lil_wheat]

I'm trying to run my remote, 4ga. power wire and my RCAs to the trunk for an amp/sub install -- I'd like to go under the backseat, but I have no idea how to take it out!?

[Chris25NJ]

i believe it just pulls out no bolts. there's two clips under the base of the seat. i think...The backseats are simple too, but don't think you need to take them out.

[brothermaynard]

NO. There are bolts in the center between the cushions and on each side, pull the cushions so you can see they are 12mm I believe...It's been years since I did it pretty sure though. I hope it helps

[lil_wheat]

Chris25NJ -- the clips are what I was originially looking for. Every car I've owned previously have had the two clips.

brothermaynard -- I saw those bolts there while I was mounting the amp to the back of the back seat; I will look into it tomorrow when it's a little warmer than 15 degrees. I'll let ya'll know.

Thanks alot for your help!