Need help with Kaminari Side Skirts..

[trickedout316]

The front and back bumper fit perfect. The side skirts are strange though. When you try to put the kam side in over the exsisting factory skirt, the back slides on good, but the front part by the wheel well, hits some body frame component. Is there any cutting required? What's the best way to install the Kam side skirts?

Thanks Everyone....

[baNanA_ryCe]

http://newcelica.org/forums/showthread.php?s=&threadid=120539&highlight=install+kaminari

http://newcelica.org/forums/showthread.php?s=&threadid=124049&highlight=install+kaminari

i think the answer is yes with stock sides, no cutting.

take a picture of what you're talking about "body frame component"

[Kuz]

yes mine have a slight gap in the front of the skirts as well...

[WillyWonka]

This should be a matter of a few screws on the underside. Place the skirt directly over the existing stock skirt. Check RJAY's response in the 2nd link above. Consider stability then esthetics in your choice of drill points. I have seen anywhere from 3-6 screws on the underside and 0-3 on the ends that are in the wheel well.

[krazykustomz]

take some pics and I can help you out as well.

[WhtCelicaGT02]

Stock side skirts? What about replacing the TRD skirts with the Kam skirts...