blackmica
06-28-2004, 11:13 PM
hi any information about the tunned powerFC by BRASHBOY for our 2zzge??
http://brashboy.net/power_fc/image/power_fc_s.jpg
HELLO
ECU of *ZZE123 does setting in an existing car basically.
I have you make a fine adjustment in attached FCcommander when it was purchased.
Use in a race is possible, too.
A lot of one used in a race, a street come.
50 of them were near last year and sold even model of a car of this place.
It is 1k degree by 10ps, torque at a horsepower, but setting depending on the situation is possible so that there is a timing change of VVIL.
Octane content does not become it in what is 95, and please make a fine adjustment.
Best Regards,
BrashBoy, CHIBA
english@brashboy.net
*have the same engine (2zzge)
*the gas octane would be affected...
any more information???
only i know it cost like $2,000.00 aprox. APEXi
http://brashboy.net/power_fc/image/power_fc_s.jpg
HELLO
ECU of *ZZE123 does setting in an existing car basically.
I have you make a fine adjustment in attached FCcommander when it was purchased.
Use in a race is possible, too.
A lot of one used in a race, a street come.
50 of them were near last year and sold even model of a car of this place.
It is 1k degree by 10ps, torque at a horsepower, but setting depending on the situation is possible so that there is a timing change of VVIL.
Octane content does not become it in what is 95, and please make a fine adjustment.
Best Regards,
BrashBoy, CHIBA
english@brashboy.net
*have the same engine (2zzge)
*the gas octane would be affected...
any more information???
only i know it cost like $2,000.00 aprox. APEXi