TRD valence with ehaust

[trdcelica01]

Has anyone installed the extended TRD ehuast with the TRD rear valence. Whenever I seem to turn corners the exhaust tip rattles against the valence creating a very annoying noise, not to mention is probably doing a number on my ground effects. Is it possible to secure it further, I noticed there doesn't look to be any other spots for the rubber fastner mounts.
Thanks
trdcelica01@hotmail.com

[HilfigerCelica]

Make sure you got the bolts on there tight and the rubber hangers are on right. I don't have a rear valence, but my TRD exhaust always stays put.

[trdcelica01]

the fasteners are on and are tight, they were actually quite diffcult to get changed when they were caked with dirt, but anyway, the exhaust dosen't seem to move much but just enough to touch the valence and then vibrate against it.

[krayze]

hey ine vibrates when making left turns up hill. if you find out how to secure it then let me know.

brian

[Bravo]

Dude... did you put the exhause on urself?

if so... did u use something like WD-40 to get the rubber rings off?

If so... soak the rubber rings in soap water, and then put it back. that will help the exhaust from moving side to side.

[Jesse IL]

The two bolts on springs where the TRD exhaust mounts to the stock piping. How much you tighten those affects how centered the tip is. Play with those. Also, i think autoxr (Scott) did something to mount the tip more securely. Post a message in mods about this.