Anyone running the Greddy E-01 Boost comtroller??

[Avenge2c]

Well like the the tittle says I'm looking for people running the greddy profec e-01 EBC. I'm getting mine delievered on tuesday and want to know any tips on hooking up the lines and how to adjust the settings. I looked on the Greddy site and there is a 44 page manuel so cliff notes from someone using it would be awsome TIA Brad

[Bing]

I am.

I strongly suggest to get the boost wiring harness that connects the e-01 with the e-manage. This way you're able to tune your car in steps of boost levels and not by airflow.

Make sure the settings are correct at the parameter settings.

Get a USB extension cable and route it to the fuse box cover on the passenger side. If you want to tune it with a laptop(which is easier to oversee) then it's just a matter of switching USB cables. That is, if you have a laptop, USB cable and the software for it.

[Avenge2c]

I don't have the emanage yet, and would probably be using the profec E-01 to tune it so I don't have to buy al the software for it.
(I drive a neon, FYI)

[Bing]

Tuning with a laptop is a lot easier because you can change fields at the same time just by entering a number. The profec will make you do increments of 0.5.

Also, you should try and figure out how the jumpers has to be set. The best you could do is to find another neon owner that uses e-manage.

[Avenge2c]

I don't have the emanage yet but when I upgrade to either the mopar Stage 3 turbo or one of the other big turbo upgrades out there I'm getting it and gonna have a shop tune it and set it. Then I'll have it all recorded incase something goes wrong and it gets re-set. Right now I just have the boost controller and I think I found some good settings. Now I need to upgrade the FMIC and get it on a dyno!

[Asha'man]

Oh then it's possible to get the pressure signal from the profec to the emanage? In that case I don't need to solder a pressure harness to the pressure sensor from my greddy boost gauge.

Gaassss! :) Please order the emanage <-> profec e01 connector, if there's any for me. :)

I'm pretty satisfied with the E01. The boost response is very nice, I have zero spikes and it has some nice features. Another nice thing is, that I don't have to always connect a laptop to the emanage to make any minor changes on my setup. For sure tuning the whole maps is much more comfortable with a laptop-

[Avenge2c]

yeah, I got it in now and love it. I do need to get a tach driver (not sure about this name) so I can get a nice clean signal to the E-01 so I can set it to run boost in relation to RPM, should help me launch better and get traction in 1st, finally !