ATTN: LarryD or anybody else who's taken their engine out RE: need help with harness

[Celica RZ]

I need help with unplugging the harness. I have just one connector left, just wonderng how you guys got it out? or did you pull the motor first? I've been squeezing and yanking and trying to turn it.....it doesn't want to come off. It has two phillips type screws holding the other part of the connector down.

It's located in the back on the Tranny. It's the bright red one in the center of the pics.

Pic1 (http://www.imagestation.com/picture/sraid18/p07a5bc8fb9f20d9c61553b7845a0c3ca/fdd1c38c.jpg)
Pic2 (http://www.imagestation.com/picture/sraid18/pa033a0b3d55f8e0e2b5737feb59a2244/fdd1c389.jpg)

Thanks for the help!

[icyjaws]

Well got the most of connecters off by hand used needle nose. I don't rember having a problem with that connector.

[larryd]

haha.. simple answer to this.. Robo Grip is your friend.. :)

[Celica RZ]

so you guys got this out al nice and easy? D@mn my fingers hurt from trying to pull that sucker out.

[larryd]

i dont remember the exact clip yer talkni about but I know there were quite a few that gave us major pains

[icyjaws]

I looked at the stuff i have and the only one back there i rember having a problem w/ was the speed sensor but i rember it being black or maybe mines just coated in oil. But you should be able to get it. If you can't you could always start to pull the motor/ tranny then remove it. BTW why are you pulling it apart anyway?

[coOOlcelica]

he is selling everything off his car......