how to make window AUOT-UP?

[Ricerboi]

anyone know how to do this. i tried looking for it but couljn't find it..

[2way]

Windows Up LF=Green, RF=Blue (passenger's switch main)
Windows Down LF=Red, RF=White/Blue

| ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V|blk/red & white |+ |ignition harness |
| STARTER|black/white |+ |ignition harness |
| IGNITION|black/orange *1 |+ |ignition harness |
| SECOND IGNITION|blue/red *4 |+ |ignition harness |
| ACCESSORY|gray |+ |ignition harness |
| POWER LOCK|brown |- |passenger kick or BCM *2 |
| POWER UNLOCK|yellow/black |- |passenger kick or BCM *2 |
| LOCK MOTOR|blue/white | |driver kick or BCM *2 |
| UNLOCK MOTOR|blue | |driver kick or BCM *2 |
| DISARM DEFEAT|blue/red | |passenger kick or BCM *2 |
| PARKING LIGHTS +|use the (-) wire | | |
| PARKING LIGHTS -|lt. green | |steering column |
| HEADLIGHTS|red/blue |- |steering column |
| DOOR TRIGGER|red/white *3 |- |drivers kick |
| DOME SUPERVISION|red/white |- |driver kick |
| TRUNK/HATCH PIN|lt. green |- |trunk light or BCM *2 |
| FCTRY ALARM ARM|arms with lock | | |
|FCTRY ALRM DISARM|disarms with unlock | | |
| TACHOMETER|brown/white | |rear of instrument cluster |
| SPEED SENSE|white/red | |rear of instrument cluster |
| BRAKE WIRE|green/white |+ |brake switch |
| HORN TRIGGER|blue/black |- |steering column or BCM *2 |
| WIPERS|blu/yel & blu/orn |+ |steering column |
| LF WINDOW UP/DN|green - red | |power window switch |
| RF WINDOW UP/DN|blue - wht/blu | |power window switch |
| SUN RF OPN/CLOSE|not recommended | | |
| RADIO 12V|blue/yellow |+ |radio |
| RADIO GROUND|brown |- |radio |
| RADIO SWITCH|gray |+ |radio |
| RADIO ILLUMINATE|green |+ |radio |

Notes:
*1 When doing remote start, this wire must be isolated from the keyswitch with the ignition relay. *2 The BCM is located just to the right side of the radio. Remove the radio to access. *3 To avoid dome light delay, use red/yellow at the driver door pin for the driver door and red at the passenger door pin for the passenger door. Isolate each door trigger with diodes. Also available @ BCM *4 There are 2 blue/red wires in the ignition harness. The correct ignition wire is the heavier gauge one and it has 1 silver hash mark. The incorrect wire has 2 silver hash marks.

[2way]

You'll need:
A whole bunch of relays..... I'm thinking at least (4) DPDT/DPSTs or (8) SPDT/SPSTs for combined UP/DN on both windows.

plus fuse(s), wiring, & a remote control device. Remote control device should be timed or only for duration of activation to avoid excessive window motor wear.

Also depends on whether you want to do just UP.... just DN... or both.