clear corner install

[blu3smoke]

can sumone explain how to install the clear corners a lil better then juss take bumper off unscrew and screw back on? I have the trd kit btw

[Jake_VVTL-i]

Go to the installs section of this website.

[cbr600drm]

just like Larry says in the install guide. All you have to do is pull the one pin out of the wheel well plastics, pull the plastic back, reach in, take the two 5/16 bolts off, pull the housing out, twist the light bulb out, swap housings, and put it back together. Should take 5 to 10 minutes per side at most.

[PinoyGTS]

I still don't see how everyone did it so easily. I had some real problems installing the clear corner on the passenger side, I could barely reach it due to the washer fluid reservoir. Did anyone else have this problem?

[caz]

Originally posted by PinoyGTS
I still don't see how everyone did it so easily. I had some real problems installing the clear corner on the passenger side, I could barely reach it due to the washer fluid reservoir. Did anyone else have this problem?

yeah I did...
that was a pain

[baNanA_ryCe]

Originally posted by caz


yeah I did...
that was a pain

i have small hands..i got mine done pretty quick...

[HilfigerCelica]

Originally posted by PinoyGTS
I still don't see how everyone did it so easily. I had some real problems installing the clear corner on the passenger side, I could barely reach it due to the washer fluid reservoir. Did anyone else have this problem?

Cut back on the sweets and you won't have that problem anymore.:chuckles:

[PinoyGTS]

Originally posted by HilfigerCelica


Cut back on the sweets and you won't have that problem anymore.:chuckles:

I don't think sweets are a problem but I can't help it if I can't fit the guns into small spaces! :chuckles:

[Ugly Pete]

i had take off half the bumper cause i didnt have a small enough wrench. for anyone that bought the APC lenses, wtf are the orange squares for?

[2000 XYR]

I had a really small ratchet wrench that I used. I had to palm it to get it by the black box, but then I was able to use it to tighten it down.

Ugly Pete -- what orange squares? I had the APCs and didn't have any orange squares. Were they really small? They might have been meant to put on the threading after you tightened the nut. That way if the nut loosed it wouldn't fall off totally. The little square would prevent that. I've seen them before but I didn't get any in mine.

[RJAY]

The passenger side was a pain.

Ugly Pete - I got those orange squares too. I really don't know what they are but it seems like they're reflectors or sumthin. Not really sure what they are for.

[Ugly Pete]

they came with my apc euro bumper lenses. they about 1 1/2 inch orange reflector squares, looks like something youd stick on your mail box to keep from getting hit :P

[Tyz_Ryde]

I still don't see how everyone did it so easily. I had some real problems installing the clear corner on the passenger side, I could barely reach it due to the washer fluid reservoir. Did anyone else have this problem?
If you don't have fog lights, just reach in through that hole. If you have fog lights, find someone with really small hands.

[RJAY]

Here's a picture of those orange reflector squares

http://photos.yahoo.com/bc/jayson3283/vwp?.dir=/My+Celica&.src=ph&.dnm=CC3.jpg&.view=t&.done=http%3a//photos.yahoo.com/bc/jayson3283/lst%3f%26.dir=/My%2bCelica%26.src=ph%26.view=t