PDA

View Full Version : alarm beeping noise???

gts-402
05-06-2006, 09:24 PM
Does anyone know how to active the beeping noise when unlock and lock door??..my car was beeping normal and now is gone...I didn't re-program or anything like that..anyone know what wrong???
XYRCNCP
05-06-2006, 10:15 PM
:moved:
drpdmazda
05-07-2006, 05:11 AM
Does anyone know how to active the beeping noise when unlock and lock door??..my car was beeping normal and now is gone...I didn't re-program or anything like that..anyone know what wrong???

what kind of alarm is it? if its aftermarket and you have the red l.e.d. on the dash is it staying on constantly rather than blinking? if so it is in valet mode, some alarms you can just open the door and hit the buttons in this sequence, 1-2-1 that will take it out, others have a small valet switch, usually in the kick panel, put the ignition to accesories and hold the button until the alarm beeps


hope that helps
gts-402
05-07-2006, 09:22 PM
yeah..i have the factory one..i will tried your last suggestion...thanks
gts-402
05-07-2006, 09:31 PM
my red light is blinking normal...hum...i tried drpdmazda idea but is not working..does anyone body else know what going on???
2way
05-08-2006, 07:09 AM
This is the beeping right... not the horn? The beeper should be located under the hood near the Engine ECU.

http://toyotasecurity.buypartsonline.biz/pdf/08586-2D860%20Instructions.pdf
gts-402
05-08-2006, 10:17 PM
dang..that alot of instruction for replacing the beeping sh**t..
gts-402
05-08-2006, 10:23 PM
Hey Sway..do you think the problem due to the Piezo buzzer??..can i just cut the buzzer and replace w/ the new one instead of re-wire everything?...anybody else ever mess w/ this beeping crap....
2way
05-09-2006, 07:56 AM
Find the piezo... and test it... I'd suspect that it has either gone bad or the splice in the cabin is bad.
aznfrenchboyca
03-10-2007, 05:11 PM
Does anyone know how to active the beeping noise when unlock and lock door??..my car was beeping normal and now is gone...I didn't re-program or anything like that..anyone know what wrong???


I am having the exact same problem. It suddenly stopped working. Anyone was able to figure it out?
v3bahumut
03-10-2007, 06:46 PM
Find the piezo... and test it... I'd suspect that it has either gone bad or the splice in the cabin is bad.


Listen to the man
deltaB
03-10-2007, 07:50 PM
Find the piezo... and test it... I'd suspect that it has either gone badMine filled up with water. Once I drained it and dried it out it was better.
dB
TRDoug
03-10-2007, 07:59 PM
This is the FACTORY alarm system???????? Mine's never beeped, I didn't know it could but want it to!! HELP haha
Celica402GTS
03-10-2007, 08:10 PM
when it's really cold out..mine sometime got a delay beep..i would press the lock button..walk away, a few feet later i hear *beep*...few second delay i say..
2way
03-12-2007, 06:49 AM
This is the FACTORY alarm system???????? Mine's never beeped, I didn't know it could but want it to!! HELP haha
The beeper should be located under the hood near the Engine ECU.

http://toyotasecurity.buypartsonline.biz/pdf/08586-2D860%20Instructions.pdfhttp://toyotasecurity.buypartsonline.biz/pdf/08586-2D870%20Instructions.pdf for the VIP RS3200 +

Those 2 .pdf's show the locations of the factory alarm modules & piezo "beeper".
TRDoug
03-12-2007, 07:26 AM
Sweet! Thank you! Gave me a good spot to put my new fog light wires through too!!!