Use Stock Fog LIght Switch for TRDs?

[gregRowe]

I just bought a set of TRD fog lights and I just finished flipping through the installation manual.

I'd like to remove my stock fogs when I install my TRDs and I'd like to use the stock fog switch for the TRDs. How easy is this to do? Anything I should watch out for?

Thanks,
Greg

[SilverRide]

Assuming the`re both 12 volts and the same wattage, there shouldn`t be a problem.

[Jesse IL]

Easy. Take your TRD wiring and find the plugs that actually attach to the foglights. Cut off those and about a foot of wire. Then find your stock foglight wiring and splice those right into there. Two wires per side, voila. I left the stock foglight plugs in place but disconnected in case I ever wanted to put them back on.

[gregRowe]

Great! Thanks Jesse!