Mallory Switch

[Wicked8o8]

I understand how to wire the nitrous to activate at a certain rpm, im confused how you wire it to turn it off as well. Orange wires turn it on so I would run it to the n20 solenoid. But to turn it off, you run the purple wire, but to where? the same n20 solenoid? Any help would be appreciated. Pics as well. thanks.

[larryd]

i dont think the purple wire is used if I recall.. the window switch actually turns it on and off with the same wire i believe.. there are 2 dials inside the switch, one for the RPM for it to turn on, onr for the RPM to turn it off..

[Wicked8o8]

ok thanks..

[nexceli216]

hey larry...i just received my new mallory digital rpm window switch. i haven't had a chance to install it but i was going over the directions and i was wondering where can i find the ignition system tach output wire to connect the green wire from the window switch?

[larryd]

its the tach wire in the ECU, look at the install guide for the AFC on the site, it will give u the pin # for the tach wire in the ECU

[nexceli216]

thank you!!

[larryd]

np

[shyvpboi]

Where do you get the Mallory window switch? I heard that you can get it from www.jegs.com , but what is the Mallory window switch's actually name or model #?

[larryd]

Here's the part number and description from Mallory Ignition pdf catalogue. As for the price, I think it's a bit over $100.

Hope it helps.

Description:
RPM Activated Switch
The RPM Activated Switch is adjustable from 3,000-10,800 RPM in 100 RPM increments and uses Mallory

[CelicaLicious]

Originally posted by larryd
its the tach wire in the ECU, look at the install guide for the AFC on the site, it will give u the pin # for the tach wire in the ECU

cool i have been trying to figure out where that thing goes..