Help with oil pressure and air-fuel ratio gages

[Ntence99]

If any one has tips on installing the oil pressure and air-fuel gauges i would appreciate it.I already have them hooked uop to power and installed in a pod.I just need to getum workin.

[jdm-style]

i think there is a install guide in the install section u might want to check it out

[jdm-style]

nm its not in there ...my bad

[Lamar Vannoy]

You need to get a "T" fitting to hook up the sender, assuming that it's an electric gauge, which will allow you to retain the factory sensor. The sensor is located right above the oil filter and uses a 1/8" NPT thread. There is an older thread in Technical Discussion that has a pic.

For the A/F gauge you just need to hook it to the O2 sensor wire. The wires can be found behind the carpet on the left side of the passenger side. Use the blue wire coming from the group of four wires on the left. There was also a post on this w/ a pic. I believe it was in the Performance Mods forum.

[dankjeweler]

where is agood place to buy the gauges?

[Ntence99]

Thanks, i appreciate the info.Ill prob finish it tomorro after i get my halfshaft and trans mount replaced.