Exhaust rubbing my new kaminari rear .. help

[Need4Spd]

Just drove my car back from the bodyshop a couple hours ago.. when I got home I noticed that my exhaust is rubbing the rear bumper :( I have the Kaminari rear.. and the Tanabe RM exhaust.. anyone have any suggestions? I can only imagine over time what it will look like :( And if the rubbing doesn't do enough damage.. the heat will.

I tried bending the exhaust down a little.. and it seems to work when its sitting there, but of course when I get back in the car and drive somewhere.. it goes back to where it was. Maybe there is some kind of heat resistant padding I can put on the bumper where the exhaust outlet is to prevent further damage? Anyone know what I could use?

Please help!

[Tom D]

I saw your car being finished yesterday chris. Charlie had a problem with my TRM fitting too. He heated the hangers and bent them a little so the exhaust can doesn't rub. See if you can call him and get him to do the same for you. BTW nice rims. The car looks nice too.

[EndlessShock]

Yeah I had that same problem when I installed my kit... The rubbing thing got me so pissed... It just keeps on vibrating the sh!t out of everything... Anyway this is what I did ("I take no responsibility for any liability to whatever happens if you do decide to do this")... I jammed something (hammer which fit perfectly) into my exhaust and bent/pused it down a little bit... When I was done there was about an inch gap between the rear and the exhaust after a week there is now about a quarter on an inch gap... Well good luck to you...

[Pure Racer]

People used exhaust hangers to hold the exhaust, I baught one but I have no clue where to install it... Also you can always go to an exhaust place and have them center the exhaust tip for you...