stock alarm outputs to run door poppers

[tonydt1g3r]

I was wondering can I use the stock alarm on my GT-S to run door poppers if I shave my door handles. I am pretty sure I can use the light turn on button for one door popper but the other one I am not sure what I can do, I was thinking of turning the red button into arm and disarm, but when it disarms it will disarm both doors, then use the black button that was used to disarm both doors to pop the other door. does this seem feasable? also I wanted to disconect the horn and hook it up to a clifford siren because the stock one sounds bad.

[voidhawk]

Sorry no answer, but another question on the same topic: I've been thinking about hooking under car neons to the alarm, so that disarming the alarm would switch on the neons. Is there an output on the stock alarm I can use to switch a relay for this? Thx!

[tonydt1g3r]

well I doubt there are outputs what you can do is run a power wire to your neons then put it through a relay that runs off the ground of the alarm headlight wire and it will go on and off with you alarm. right now i have my neons set to when the door opens and closes.