HELP! How to install TRD style sideskirts and rear valence?

[YellowCelica_GT]

ok...i am kinda lost on how to install my TRD replica sides and rear.

For thet sides, do i have to take off the factory ones or do i put the TRD sides overtop of the factory sides?

Also, how do i attach the side skirts? screws? tape? where do i put the screws? do i need to drill holes?

also, for the TRD style rear, how does it go on? screws? tape? where do the screws go? any drilling required?

my kit didn't come with screws...where do i get them from? and what kind and size of screws should i get?

I need someone to fully explain to me how to install the TRD replica sideskirts and rear.

All the help will be really appreciated!

Thanks

[badboy58]

I have the RMM Kit, and my sides were drilled on the sides in the wheel well and the on the top in the door. The stock sides stayed on it. The Rear valance is drilled in the wheel well too and also has 3m tape around the top for added help. Hope this helps. The kits are similar.

[yota_racer]

For the TRD sides, you have to remove the stock sideskirts.

[ishido]

remove stock side skirts, there are plastic clip deals on the bottom... a LOT of them. To install the TRD sideskirts, it only requires about half of them. The rear part (that goes in the rear wheel well) needs a plastic bracket that fills in 2-5mm and holds the back securely.

I don't have this bracket, but it holds up fine. I saw it on an action package, but for some reason I didn't have the bracket. Glad I finally figured out what is supposed to go there. Unfortunately my dealer said it wasn't available, as well as the action package, nor any pieces of the action package.

[ishido]

hmmmm, just noticed you said TRD replica...
in that case... (shrug)

[nccelica]

mines a replica and ijust slid it over the top of the factory ones and did what badboy58 said, cept im to lazy to put tape on it hehe