Gauge pods/gauges

[Atr3yuRocks]

Found these gauges, wondering if they were any good cuz they are pretty cheap:
http://www.advancedjdmparts.com/home.php?cat=260
I'm lookin to get the A/F gauge and the Oil pressure gauge. Also does this look good, its molded in ABS:
http://www.glowshiftdirect.com/index.asp?PageAction=VIEWPROD&ProdID=45.
Anyone reccomend getting something else? I'm not lookin to spend too much money on this stuff. Thanks

[U KnOw MeH Fo]

if you want cheap. yeah that's cheap. and cheap looking. gauges are ok. but that black plastic (they probably make gray) but you have to attatch it to your pillar. if you could get a whole pillar that would be nice but you have to attatch that and you will see how it just goes ontop of it and it's not molded to your pillar.

save some money up and do Carbon Fiber with those gauges.

[lVlemphizStylez]

do not waste your money on a narrowband O2 A/F gauge....It's nothing but a useless ricer light show

[drewd]

www.prosportgauges.com

[blitzceli]

1) Any guages thats say "jdm" is a sign of low quality. If you dont want to spend much check into prosport gauges.

2) the bolt on pillars dont fit 100% no matter who you buy them from. You usually have to put them in a oven to heat them up to form them to the actual pillar. I woulf get the gauges put in the center console or get an actual full replacement pillar.

[Atr3yuRocks]

Thanks everyone for the fast responses. Ya those pro-sport gauges do look a lot nicer. I'm actually gonna get the oil pressure & voltage gauges rather than the A/F gauge anyways, and I'll most likely end up putting them in the center console as I TOTALLY forgot about that option lol
Anyways thx again :wave: