Kaminari Kit

[celica604]

How hard would it be to install the urethane kit and race wing yourself?

[warpig]

Not too hard. First take your front and rear bumpers off ---- Make sure that you get all the bolts, all the front plastics, and all the pop rivets out --- If you feel that you won't remember where they go --- then label each bolt --- (this is what I did down to the actual position of the bolt). When you get your bumpers in --- get someone to help you hold them in position (this is what I did as well) ---- bolt everything up --- but not torqued --- just enough to keep the front and rear Facisas in place and then tighten up the bolts up ---- you should start from the middle --- then work your way out --- be sure to tighten one side a little and then tighten the other side a little --- this will reduce the risk of any shifting --- once you have it fit and matched where you feel it looks best --- then you may have to do some of your own smoothing and sanding to get the lines to match up 100%. Please take the bumper off when you start sanding and filing --- you wouldn't want to slip and ruin your factory paint. REMEMBER --- measure twice cut once. Keep trial fitting the bumpers to see if they match up --- don't just keep filing and sanding and decide --- Well, that might match and when you put it on you realize you have removed too much material. Just take your time and don't be afraid to ask for help from someone you know. Peace

[EndlessShock]

Thats exactly what I would do and did warpig... It would also help a lot if you have a friend lending a hand holding things in place while you screw/bolt things down...