Wheel Wells???

[2KGTrd]

I just got a set of spacers that are going to push my OEM GTS rims to the edge of the fender.
The spacers are 1.5"

I know that I will need to either roll the fenders or cut them.
Which of the two is the best option?

[Shizuma]

Roll them, cutting that bend along the inner lip of the fender will make it lose a lot of its rigidity. Unless you don't care what it looks like or you're going to be putting on fender flares: roll the lip.

P.S. : Be careful tooling around with spacers that large, they're going to increase your scrub radius and may increase wear on the ball joints....also if they're not hubcentric GET SOME HUBCENTRIC RINGS.

[Projeckt Celica]

Roll them do not cut them rolling them is a better option!
http://i557.photobucket.com/albums/ss11/stickl46/turp_0710_01_ztoyota_celicafront-1.jpg
Don't run your mouth run your car!

[XBernie]

What drop do you have? and how good are your struts
You wont have to worry about rubbing unless your dropped more than 1.5" or taking a ridiculous ramp/dip.

[2KGTrd]

I'm on trd springs with OEM struts.
i know bernie had a thread about rolling the fenders, but exactly what all is there too it.
I just don't wanna cut the tire so I'm taking the steps necessary to avoid it.

[XBernie]

Just push them out, the only reason i sliced my tires is because im dropped 4.5" you wont run into any problems since your lowered only an inch around.

[Gootz311]

I cant wait to see pictures. :drool:

[Mido]

im dropped 4.5"
WOW Bernie, are you serious??? i need to shoot you a pm on what size spacers to get for the 57c's

[2KGTrd]

pics are up in the readers ride section.

http://www.newcelica.org/forums/showthread.php?t=316966
I like the look with the stock gts rims

[7th Gen]

Oh yeah, sitting wide