Car shaking after dropping it with D2 coilovers

[OssiR]

Hi fellows,

I just installed the D2 set to my car (in Finland) and I like the ride height now, the car dropped maybe something about 2"-3".. I adjusted the wheel alignment, camber adjustments etc. and rear cambers are still out of spec, there isn

[DANZZT231]

It is the c.v joint not operating at optimum angle due to extreme lowering. I had that problem too when I used to drive 2003 Corolla.

My car is lowered with Bilstein PSS, it is about 2inch drop and it is fine at that amount of drop, so try raise the car to achieve 2 inch of drop and see how you go.

[bionictony]

shaking on acceleration also means that your inner cv boots might need grease inside. when was the last time it was rebuilt? check the axles first to see if they are fully in the transmission. then raise your car to a 2 inch drop. if the shaking still happens then try stock height again. if it shakes at stock height your axles might just need a rebuild.