ECU pinout

[gto78]

I did a search, found some schematics on our ecu's and still have a question. I am looking for the wires on the ecu that are jumpered to simulate the car being placed in "park". I just did a swap from auto to stick tranny. The car will not start unless I leave the shift selector switch installed and place in the park position. That meant i had to unbolt it from the auto tranny and leave it hangin under the car and placed in the park position. Thats not the way i wanna leave this thing installed. I want to do it correctly and make it more like the factory does. At the same time i'm lookin for the wires on that switch that activate the reverse lights. anyone have some wire colors for me??? thanks

[gto78]

Nevermind I just took the switch off and hit it with an ohm meter, and figured out which wires to jumper for park, and which wires to run to the reverse switch on the manual tranny. Everything's perfect now, no loose, hanging wires and everything starts and lights up like its supposed to...

[Griffin]

Rofl - sorry bro - was gonna answer you tomorrow after I had a change to check a wiring diagram :) - Glad you got it figured out.

Griffin

[coolstorm92]

so what color is the reverse wire and what is the easiest accesible location on gts 6spd. let me know.

Thanks,
Dan V.

[gto78]

the bottom wires on this pic are to the reverse lights on the connector from the auto tranny. Those two wires i have plugged in are now connected to the 6 speed tranny reverse switch. http://www.imagestation.com/picture/sraid26/pfbd0fe28e22fcefe49e76fd9a9c8406a/fd838d91.jpg