fuel rail question

[NRojas]

anybody know what the part number is for a quick connect coupler that connects to the oem fuel line and converts to -6an fitting? I remember that somebody had posted previously but I wouldn't find it after a search.

[monkeywrench]

I've only seen one and it is apparently designed for a slightly different quick connect fitting because it has the dangerous tendency to "snap" but not be fully secured. If you do go this route be sure to give it a good pull and move it around a bit to be sure it's really on there.

[NRojas]

thanks for chiming in monkeywrench, will be ordering some stuff from you in a little while...

would i be able to cut the stock hose and add a barb fitting? is this how it's done most of the time?

cut the hose.....
http://im1.shutterfly.com/media/47a1db37b3127ccefd74f350be1f00000030O02Acs3DFk5Zsg e3nw4/cC/f%3D0/ps%3D50/r%3D0/rx%3D720/ry%3D480/

then use a fitting like this....
http://static.summitracing.com/global/images/prod/large/aer-fce1512_w.jpg

would this be safe?

[Smaay]

barbs can do the job but i dont trust them. I have discovered the secret fitting that does the job. look for my PM