Those with an air/fuel gauge.....

[Pinoyspd17]

sup guys...

where to mount the O2 sensor wire???

besides the O2 wire in the engine bay ecm, anyone know where to tap this wire in the interior of the car?...

ive read the install guide for it here on the forum, but i cant seem to find the "blue"wire that the guide specifies...it specifies an all blue wire that should be bundled with other wires in the passenger side footwell...

easier question:
Where did you all tap your O2 sensor wire?..

THANX guys...

[Mistrimeat]

http://www.dcm7thgen.org/installs/gauges/

[Pinoyspd17]

sup again guys...

the wires currently tapped to the engine bay o2 wire..

unless someone knows where the car interior o2 wire is?...

thanx

[Chris25NJ]

damn that looks so easy to do. I think i'm gonna go for it. Anyone know where you can get the dual guage pod pillar? I know i've seen posts about it awhile ago. Think it's about $100? How much for the guages?

[Pinoyspd17]

sup guys..

get the whole replacement 2-pod gaugepod from www.titanmotorsports.com ..i got it for $93 shipped...

and get the gauges from www.egauges.com ...i got the air/fuel and voltmeter gauges..i got them for $100 shipped..

installs easy like the guide says: wire the 12v wires to a power source....wire the grounds....(or you could make it even easier by not taking out yor gauge cluster or dash while you thread the wire to where you wanna tap them to)

and the a/f gauge has a third wire: the O2 sensor wire....you can wire it to the engine bay ecu (thanx larry!)....or (like in the 1st post) the o2 wire in the interior......

ill post pix of my setup later today (01/15)

Anyone know where this interior o2 wire is???...

thanx