PDA

View Full Version : main nitrous line


zcs626
04-30-2003, 07:12 AM
im sure this has been brought up before, but it didnt pull up on a search, it was probably buried in a thread about something else, anyway,

where did you guys run your main nitrous line? under the car or through the interior of the car? im about to run mine but i wanted to get a general idea as to where you n2o veterns put yours. thanks in advance. :)

JimmyPusPounder
04-30-2003, 07:43 AM
My bottle is behind the passanger seat with the nozzle facing towards the drivers side. I ran my feed line through a gromet on the floor behind the drivers seat and ran it underneath the car. The line comes up in the engine bay through the front fender and pops out at the top of the headlight. All I did was pop off the plastic lining in the wheel well run the line through and pop it back on.

Quick_GT-S
04-30-2003, 08:29 AM
Have the bottle facing forward if possible.

Cabel
04-30-2003, 08:59 AM
I ran mine through the interior in the channel under the door sill, as did IRL. Living in Canada, I don't drive my car in the winter, but IRL does so just opted not to expose it to the elements.

zcs626
04-30-2003, 11:55 AM
good point, i'll run it through the car.

FL Honda Stompr
04-30-2003, 12:10 PM
mine is run through the car, bottle mounted on passenger side of trunk, and running through the interior panels, it then exits to the engine bay through a gromet up behind the dash.

zcs626
04-30-2003, 12:33 PM
thanks a bunch guys

celicauk
04-30-2003, 12:39 PM
For the best install use a bulkhead adapter to pass the line into the engine bay, you'll need the adaptor and two -4an end fittings to do this. If you are using a gauge its also a good point to put in the T piece as you can get bulkhead Tee's too.

Cheers

zcs626
04-30-2003, 12:45 PM
thanks again :)

Brother Mark
04-30-2003, 09:24 PM
i ran the line under the car. looks very clean to me. line is very safe cuz itz protected by the chassis, strapped ontop of other lines.

RedNOSceli
05-03-2003, 11:49 PM
the the grommet on the Driver side...behind the break booster