How do i remove my molly designs rear peices

[gqsean124]

i wanna change my molly designs rear to the trd rear valence.... just wondering if anyone knows how to properly and safely remove the molly rear

[pokgai]

how much for the molly rear if youre selling???

sorry i dont know how to take it off though...

[celica girl]

there are two screws for the center piece... take those out and then it's just held on with double sided tape tape.... for the end caps those are held on with a single screw and double sided tape.... I'm not sure how to go about removing double sided tape though... probably the same process as debadging a celica... heat it up and cut off the tape with floss or fishing wire...

[Mistrimeat]

Originally posted by Celica girl
I'm not sure how to go about removing double sided tape though... probably the same process as debadging a celica... heat it up and cut off the tape with floss or fishing wire...

Yep, exactly. Then use some goo-gone to get rid of any residual adhesive left by the tape.

[gqsean124]

thanks people

[gqsean124]

another question, the goo-gone wont f-up my paint will it?

[celica girl]

Follow the directions on the back really carefully... you should be fine... just don't leave the goo-gone on the paint surface too long I guess...

[Mistrimeat]

Nah it wont hurt the paint.

Actually I think a better alternative is the 3M adhesive remover, its made for automotive use and will not harm cured paint. It comes in a spray can now, I think.