Vision HID Install Guide by RADR1732

Equipment used:

1.) 10mm socket

2.) Pliers

3.) Double sided cusioned tape

4.) Picture wire or Ornament wire

5.) Electrical tape

6.) Two 25 amp Mini Fuses

After removing your front bumper, remove the headlight assembly. Here are the pics of the three screws you need to take off to remove the headlight assembly as marked with the red circles:

Screw #1

Screw #2

Screw #3

Before pulling out the assembly, make sure to unplug the turn signal, parking light, low beam, and high beam.

After removing the headlight assembly, remove the old bulb. Then carefully insert the HID capsule inside the projector. Make sure to match up the tab on the capsule with the slot on the projector assembly as marked with the red arrow. Here is the pic:

Capsule insertion

Remove the old wire holder for the old bulbs by loosening the screw and removing it. Leave the screw there because you'll need it to hold the new wire in place. Use the picture wire/ornament wire to hold the HID capsule in place such as in this picture:

Lock it down

Capsule lock down side view

Make sure to run the picture wire/ornament wire in between the electrode wire on the capsule.

Find a place to secure the balasts and the starter. The starters already has a cusioned adhesive on it. Use the double sided cusioned adhesive tape to secure the ballasts. On the passenger side, I placed the ballast behind the power steering fluid container, and the starter under the headlight assembly. On the driver side I placed both the ballast and the starter underneath the headlight assembly.Make sure to clean the area where you are placing the units to ensure proper adhesion. Here are some pictures of my ballast/starter placement.

Driver side placement

Passenger side placement

The wiring diagram provided with the kit is very simple. It is truly plug and play. When plugging in power supply wire make sure you match up red with red and black with black. After wiring your kit, plug in the high beams, turn signals, and parking light. Place your headlight assemblies back in place and resecure them with the 3 screws. Reinstall you front bumper.

Finally, you have to replace two fuses inside the fuse box. They are your headlight mini fuses. Stock they are 10 amps, but you are gonna replace them with 25 amp mini fuses. They are not included in the kit.

Fuses to replace

Enjoy!!!

Pics after install

I do not claim responsibility for any problems that may come up due to this instally guide. Remember that this is what I did during my install and your install maybe different. If you are at all unsure about doing this install yourself, have a professional do it.