To tell you the truth I used m10x1 bolts ......but the pressure from the MC was strong enough to push out the brake fluid through the threads. That being said, I used clear tubing with MC bleed port adapters so I could see the bubbles coming out when I bench bleed ....it seems good and I would imagine if there were problems I would only see bubbles / fluid coming out of 1 port tube.
I'm looking now to try and find correct brass fittings but I don't think the MC is the problem.
But brass fittings need to be used to lock in the fluid. I'm having a hard time finding those fittings.
Last edited by scippybaby; 01-20-2019 at 02:03 PM..