NewCelica.org Forum banner
Cancel
Create thread New Garage Forums

FS: Cobb Intake For The 2ZZ

Jump to Latest
1 - 12 of 12 Posts
C

Curt

· Registered
Joined
·
287 Posts
Discussion starter · #1 ·
This is a pretty neat intake for the 2ZZ setup, originally designed for use on a WRX & STi Subaru. I planned to use this as an interim intake on my 2ZZ-swapped Spyder until the full Rotrex. Our MAF plugs right in (although not included) and it has vanes as well. I believe there are write-ups on this. Retails for around $150, I'll sell for $100 shipped to lower 48. PM me.

Image

Image
 
#2 ·
oh snap, someones gonna snap that right up. hell, you could use a coupler to put that on the end of a wai or cai pipe and extend the sensor wiring down to it. but i can't afford $100 for that. good bump for ya
 
#6 ·
Is it an all-straight piece or does it bend at either end a bit?
 
Save
Reply Quote Like Like
#10 ·
Do you know the Cobb part number for this and which makes and models it's for?

Thanks.
 
Save
Reply Quote Like Like
1 - 12 of 12 Posts
About this Discussion
11 Replies
7 Participants
Last post:
Curt
NewCelica.org Forum
posts
5.6M
members
60K
Since
2001
A forum community dedicated to all 7th Generation Toyota Celica owners and enthusiasts. Come join the discussion about modifications, troubleshooting, engine swaps, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Discussion Parts For Sale Repair & Maintenance Forced Induction & Nitrous Introduction Zone