Forum banner
1-8 of 8 Results
  1. Repair & Maintenance
    Hi, I have a 2000 Toyota Celica 190. When I accelerate, at around 5 or 6k(depending on engine temperature), the car hits a dead spot. It will not accelerate for about 5 seconds and then it will begin to accelerate. Im not very good at explaining this but I really need help. I think my fuel...
  2. Want To Buy Ads
    As stated on the title I'm looking for a used cai tube (brand not ebay) so with out the air filter but i do need the screws for the MAF sensor
  3. Performance Mods
    Hey guys! Anyone ever used a MAF spacer,to raise the MAF sensor higher than it's normal place and make the intake tube more free flowing?? I am thinking about this mod,lately... Discuss,please!
  4. Repair & Maintenance
    I put in a CAI about 9 months ago and finally read the bluebomber mod so I did that and everything fit good. When I put it all back in and started the engine it revs up to the idle and then quickly slows down then stalls out. If I rev up the gas it is responsive but then quickly goes down and...
  5. Parts For Sale
    Someone decided it was more important to text than to see if I was stopped at the red light in front of them. So, my poor GT-S is totaled and I'm selling some of the parts that were not destroy by the lady that rear-ended me (lancer drivers right?) (used)AEM cold air intake $150 obo...
  6. Forced Induction & Nitrous
    Hi! Since the installation of an A/A intercooler to my supercharged setups (both the MP62 and the TVS R1320), I had some issues with respect to idle and throttle opening rate vs. A/F ratios. To be honest, I had throttle opening rate vs. A/F ratios issues when I also had no intercooler at my...
  7. Introduction Zone
    So I'd like to say that as one of my first official "threads" on newcelica, that this kind of a community seems to make the world go round, and countless people would be lost without the open hearted people running and maintaining this website. For that, much appreciation. Next- I'd like to say...
  8. Performance Mods
    For those who have thrown away/cut apart the original top to the factory airbox while installing an aftermarket intake, it seems that ordering an entire airbox would be the only solution apart from meticulously fabricating your own piece. However, this approach will cost around $350 from an OEM...
1-8 of 8 Results