[mtskibum16]

I always just double nut the end and you can run them in like that. There is a tool for it but I don't have one. The old ones you can just grab with vise grips and turn them out (since you aren't worried about the the threads. Also, since you have the ARP studs (and you won't need to replace them again) you should loctite the studs into the head. Good luck.

 

[mtskibum16]

Originally posted by Smaay
ARP studs should be only tightened hand tight with their application lube

Listen to him^^^^^^ I have no specific info on ARP studs so....

 

[mtskibum16]

Originally posted by Tikked Again
Loctite?

oops....don't know where my head was. lol Smaay, do the factory studs remove with the torx bit? I haven't even looked. I decided to stay with the 2 stock studs and 3 bolts.....