Forum banner
1 - 1 of 1 Posts

· Registered
318 Posts
Discussion Starter · #1 ·
I was looking at some wiring in my car and noticed that when my amplifier was put in, someone wanted to take a short cut and they wired my speakers from my new amp into the stock amp.

I need to know how to run the wires directly to the speakers from the new amp (Kenwood 5-Channel). Do I just wire directly from the amp? Is there going to be any sound problems from this? I have an aftermarket stereo installed and not sure how it's wired if that would be a problem with bypassing the internal amp.

I plan to upgrade the speakers later and figure while the car is apart right now, it would be the easiest thing to do.

Any help would be appriciated...
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.