NewCelica.org Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
4,660 Posts
Discussion Starter · #1 ·
Finally made my way to the strip to see if Killerm's tq brace would live up to its purpose.

Before the tq brace I was running 15.6's consistantly
After the tq brace i ran a 15.5 on a crappy ass oilly track

Traction was minimal and wheel hop was horrible, but that was due to track conditions. On another track that is cleaner, and provides good traction, i could have probably gotten down to 15.3~15.1...I was litterally fighting for traction in first...nothing but spin :(

So, I must say that brace is def. worth 50$, an the vibrations.
 

· Registered
Joined
·
4,660 Posts
Discussion Starter · #6 ·
Thats Killerm's Engine TQ brace...
It doesn't bang against the engine at all.
So far, the only adverse effects are a slight vibration at low RPM
Here is a picture of it after I installed it. In that picture it is against the engine, but it can be adjusted so that there is a space between the brace and engine.
 

· Registered
Joined
·
4,660 Posts
Discussion Starter · #9 ·
Its on the left side of the engine bay
There is no need for a second one for the right side, as this does the job very well by itself.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top