NewCelica.org Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
427 Posts
Discussion Starter #1
anyone know a good machine shop in south jersey. My last engine build I used a place in north philly but that was like 8 yrs ago. They did an ok job so if needed (and if their still open) I could go back but looking for something closer ( I'm 5 mins from WW bridge). Not sure what I'm going to have done yet. might build a stroker or use the rods and pistons from my 1st build and just bored the block and balance the crank. Or I may just hone the cylinders and put new rings on the stockers.
edit: working on my mr2
 
1 - 1 of 1 Posts
Top