Forum banner
1 - 3 of 3 Posts

· Registered
9,946 Posts
Originally posted by GT2QQ0:
I had to drill 2 new holes on each side cause it required 4 screws on each end.. i reused the stock holes... but the weird part was that i had to drill out these 2 weird things sticking up from under the stock wing.. they were located on both sides between the stock holes... very weird..

my TRD tyle wing looks a bit different then yours.. its made of fiberglass and its only got 1 screw on each side holding that little cover on the sides on the wing, (the little cover the hides the screws to connect the middle part of the wing) i think the quality of your wing was probably better then mine.. but its basicly the same thing...

<IMG SRC="" border=0>
<IMG SRC="" border=0>
Where did you get your wing from?

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.