NewCelica.org Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
3,711 Posts
Discussion Starter #1
Hello,

Just In case this isn't related to my turbo I figure i would post here as well and get some suggestions. I'm getting this codes.

P1300 (Igniter circuit malfunction No. 1)
P1305 (Igniter circuit malfunction No. 2)
P1310 (Igniter circuit malfunction No. 3)
P1315 (Igniter circuit malfunction No. 4)

My car won't start. It just died while i was driving.

I have an emanage.


THanks!
 

·
Premium Member
Joined
·
9,606 Posts
Originally posted by twistedGTS
My car won't start. It just died while i was driving.

I have an emanage.
Did you check all the connections you made/spliced for the emanage? Wouldn't surprise me if one came loose.
 

·
Registered
Joined
·
3,711 Posts
Discussion Starter #3
yeah they seemed fine
 

·
Vendor
Joined
·
15,564 Posts
Could be your e-manage going bad - you could always try hooking the IGT and IGF circuits back up to stock and see if it starts.
 

·
Registered
Joined
·
3,711 Posts
Discussion Starter #5
i took the emanage off and still the same problem. It starts up for a second the it dies. I have the PO100 code now (sensor malfunction) if i unplug the MAF sensor the car starts up and stays on... :confused:
 

·
Vendor
Joined
·
15,564 Posts
Try putting the MAF wires back to stock (bypass e-manage) and see if that works for ya.
 

·
Registered
Joined
·
3,711 Posts
Discussion Starter #7
the emange is completely off, i hooked the wires back to stock and it still does the same thing. Starts up for a sec then it dies.
 
1 - 8 of 8 Posts
Top