NewCelica.org Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
486 Posts
Discussion Starter · #1 · (Edited)
I have searched but i can't find any info.

I'm fitting my wideband O2 sensor tomorrow, ready to tune the PFC i have. Which wire can i get the rpm feed from?

Thanks in advance.
 

· Registered
Joined
·
1,820 Posts
Oli hope this helps



Speed signal is in the red, and RPM signal is in the green connector.

Pin No.19 green highlighted area (white line with brown marker) is the line for RPM.



You can also splice the ECU for a RPM feed.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top