90910-02103 Flywheel Bolts X8
49nm - 36ft lbs

90119-08079 Clutch Bolts X6
19nm - 14ft lbs
start at knock pin first

can someone verify this with me?

 

i think you have to torque it at a certain point, mark it and turn it 90 degrees. or something like that

 

i covered this in my guide, doesnt anyone use them? its 36 ft lbs plus 90 degrees for the flywheel bolts, the clutch pressure plate is 15 ft lbs

 

i was reading right out of the manual lol.... but wasn't sure if anyone had problems with them being under torqued

and smaay i read all your stuff lol

 

found your guide thanks

http://www.newcelica.org/forums/showthread.php?t=334603

I didn't know it exists?

Do you have torque specs on bolts for tranny to the engine block?

 

Do you have torque specs on bolts for tranny to the engine block?

The two upper ones that bolt from the tranny side into the engine block ar 47 ft-lbs.
The two middle ones on the differential side that bolt from the block into the tranny ar 35 ft-lbs.
The two lower ones that bolt the block girdle to the tranny bellhousing are 17 ft-lbs.

 

sorry thats something you cant buy, it takes years of experience to dial the elbow in just right

 

Thanks for Torque specs, Appreciat all your information